Rki-instruments 65-2432RK User Manual

RKI Instruments, Inc.1855 Whipple RoadHayward CA 94544Phone: 800-754-5165 Fax: 510-441-5650 65-2432RKCarbon Monoxide TransmitterOperator’s Manual Pa

65-2432RK CO Transmitter • 10 Start Up This section describes procedures to start up the CO transmitter and place the transmitter into normal opera

65-2432RK CO Transmitter • 11 Maintenance This section describes maintenance procedures. It includes preventive maintenance, troubleshooting, and c

65-2432RK CO Transmitter • 12 Performing the response test 1. Screw the regulator into the calibration cylinder. The sample will begin to flow2. All

65-2432RK CO Transmitter • 13 • Unable to accurately set the zero or response reading during the calibration procedure.• The transmitter requires f

65-2432RK CO Transmitter • 14 Replacing the charcoal filter 1. Turn off the controller.2. Turn off or unplug incoming power at the power source end.

65-2432RK CO Transmitter • 1511. Reconnect the detector leads to the detector terminal strip as shown in Table 3 and Figure 3, Wiring the CO Transmit

65-2432RK CO Transmitter • 16CAUTION: Allow the replacement detector to warm up for 5 minutes before you continue with the next step.11. Calibrate t

65-2432RK CO Transmitter • 17mV (± 2mV).3. Unscrew the regulator from the zero air calibration cylinder.Leave the sample tubing connected to the regu

65-2432RK CO Transmitter • 18Parts ListTable 5 lists replacement parts and accessories for the CO transmitter.Table 5: Parts ListPart Number Descript

65-2432RK CO Transmitter • 2 Product Warranty RKI Instruments, Inc., warrants gas alarm equipment sold by us to be free from defects in materials,

65-2432RK CO Transmitter • 3 Table of Contents Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

65-2432RK CO Transmitter • 4 Overview This manual describes the carbon monoxide (CO) transmitter. This manual also describes how to install, start

65-2432RK CO Transmitter • 5 Description This section describes the components of the CO transmitter. The transmitter consists of the CO detector,

65-2432RK CO Transmitter • 6 Charcoal Filter The disc-shaped charcoal filter is secured to face of the CO sensor with a rubber boot. The charcoal fil

65-2432RK CO Transmitter • 7 Junction Box Use the junction box to install the CO transmitter at a mounting site that is remote from the controller.

65-2432RK CO Transmitter • 8 If the CO detector is mounted to the junction box, skip to step 5. If not, continue withstep 2.2. Remove the junction

65-2432RK CO Transmitter • 9 10. Connect the wires to the to the applicable controller transmitter terminal strip as shown in Figure 3. Figure 3: W