Rki-instruments 65-2498RK User Manual

www.rkiinstruments.com65-2495RK/65-2498RKHydrogen Sulfide DetectorOperator’s ManualPart Number: 71-0155RKRevision: 0Released: 2/16/11

6 • 65-2495RK/65-2498RK H2S DetectorStart UpThis section describes procedures to start up the H2S detector and place the detector into normal operati

65-2495RK/65-2498RK H2S Detector • 7MaintenanceThis section describes maintenance procedures. It includes preventive maintenance, troubleshooting, an

8 • 65-2495RK/65-2498RK H2S Detector5. Unscrew the calibration cup from the H2S detector. Make sure that you do not loosen the detector housing cap w

65-2495RK/65-2498RK H2S Detector • 9Probable causes• The plug-in sensor has been replaced and the shorting jumper has not been removed.• The calibrat

10 • 65-2495RK/65-2498RK H2S DetectorWARNING: You must replace the plug-in sensor with the same type of sensor that is installed. A detector cannot b

65-2495RK/65-2498RK H2S Detector • 116. Guide the detector leads of the replacement detector through the controller conduit hub or junction box condu

12 • 65-2495RK/65-2498RK H2S DetectorCalibrationThis section describes how to calibrate the H2S detector. It includes procedures to prepare for calib

65-2495RK/65-2498RK H2S Detector • 13knob counterclockwise to open it. Gas will begin to flow.4. Allow the gas to flow to the detector for 2 minutes.

14 • 65-2495RK/65-2498RK H2S Detector81-1051RK Regulator with gauge and knob, 0.5 LPM, for 34AL/58/103 liter cali-bration cylinders81-1117RK Calibrat

65-2495RK/65-2498RK H2S DetectorWARNINGRead and understand this instruction manual before operating detector. Improper use of the detector could resu

65-2495RK/65-2498RK H2S DetectorProduct WarrantyRKI Instruments, Inc. warrants gas alarm equipment sold by us to be free from defects in materials, w

65-2495RK/65-2498RK H2S DetectorTable of ContentsOverview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

65-2495RK/65-2498RK H2S Detector • 1OverviewThis manual describes the 65-2498RK hydrogen sulfide (H2S) detector. This manual also describes how to in

2 • 65-2495RK/65-2498RK H2S DetectorDescriptionThis section describes the components of the 65-2495RK and 65-2498RK detectors. The 65-2498RK includes

65-2495RK/65-2498RK H2S Detector • 3Detector Housing BodyThe detector housing body protects the electronic components within the housing. Use the mou

4 • 65-2495RK/65-2498RK H2S DetectorNOTE: If your application does not require a specific mounting site, mount the detector at approximately breathin

65-2495RK/65-2498RK H2S Detector • 56. Connect the two wires to the detector using the terminal block.CAUTION: If using shielded cable, leave the dra