Rki-instruments 61-1001RK User Manual

www.rkiinstruments.com61-1001RKHydrogen DetectorOperator’s ManualPart Number: 71-0194RKRevision: BReleased: 4/12/11

6 • 61-1001RK Combustible Gas Detector3. Turn on power to the controller. 4. Turn on the controller.5. Verify that the controller is on and operating

61-1001RK Combustible Gas Detector• 7NOTE: Performing a response test on the hydrogen detector may cause alarms. Be sure to put the controller into i

8 • 61-1001RK Combustible Gas DetectorTroubleshootingThe troubleshooting guide describes symptoms, probable causes, and recommended action for proble

61-1001RK Combustible Gas Detector• 9hub or junction box conduit hub, then screw the mounting threads of the detector into the hub. If necessary for

10 • 61-1001RK Combustible Gas DetectorNOTE: The following procedure assumes the use of a calibration kit which includes a calibration gas cylinder,

61-1001RK Combustible Gas Detector• 11NOTE: If you do not allow the gas reading to decrease below the alarm points, then unwanted alarms may occur.3.

61-1001RK Combustible Gas DetectorWARNINGRead and understand this instruction manual before operating detector. Improper use of the detector could re

61-1001RK Combustible Gas DetectorProduct WarrantyRKI Instruments, Inc. warranties gas alarm equipment sold by us to be free from defects in material

61-1001RK Combustible Gas DetectorTable of ContentsOverview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

61-1001RK Combustible Gas Detector• 1OverviewThis manual describes the 61-1001RK hydrogen detector (internal amplifier type). This manual also descri

2 • 61-1001RK Combustible Gas DetectorDescriptionThis section describes the components of the NC-6205-01 and 61-1001RK detectors. The 61-1001RK inclu

61-1001RK Combustible Gas Detector• 3The bottom conduit hub includes a 3/4 in. x 1/2 in. reducer that allows you to screw the detector into the hub.

4 • 61-1001RK Combustible Gas Detector2. At the mounting site you select, hang or mount the junction box with the detector facing down (see Figure 2)

61-1001RK Combustible Gas Detector• 5Figure 3: Wiring the Hydrogen Detector to a ControllerStart UpThis section describes procedures to start up the